Garage Telpost Installation Guide

There are some vital steps in making sure the installation of your Telpost in your garage setup meets installation and engineering requirements.

STEP 1 - Remove these bolts

STEP 2 - Undo lock nut & wind out threaded rod, no more than 100mm

STEP 3 - Slide post out to desired height within 50mm

STEP 4 - Replace bolt & washer & tighten

STEP 5 - Ensure washer & two nuts underneath bean & tighten

STEP 6 - Ensure washer & two nuts underneath beam & tighten

STEP 7 - Tighten lock nut against bottom nut

 

If you require engineering or other details please contact our office on 02 9623 7363

To Top